ZyXEL Communications XS1920 Series User Manual page 145

Figure 103 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Table 63 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL DESCRIPTION
Link
Note: Do not configure this screen unless you want to enable dynamic link aggregation.
Aggregation
Control
Protocol
Active Select this checkbox to enable Link Aggregation Control Protocol (LACP).
System LACP system priority is a number between 1 and 65,535. The switch with the lowest system
Priority priority (and lowest port number if system priority is the same) becomes the LACP "server".
The LACP "server" controls the operation of LACP setup. Enter a number to set the priority of
an active port using Link Aggregation Control Protocol (LACP). The smaller the number, the
higher the priority level.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple
ports.
LACP Active Select this option to enable LACP for a trunk.
Chapter 17 Link Aggregation
XS1920 Series User's Guide
145