ZyXEL Communications XS1920 Series User Manual page 184

The following table describes the labels in this screen.
Table 81 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping
LABEL DESCRIPTION
IGMP Snooping Use these settings to configure IGMP snooping.
Active Select Active to enable IGMP Snooping to forward group multicast traffic only to ports
that are members of that group.
Querier Select this option to allow the Switch to send IGMP General Query messages to the VLANs
with the multicast hosts attached.
Host Timeout Specify the time (from 1 to 16 711 450) in seconds that elapses before the Switch
removes an IGMP group membership entry if it does not receive report messages from
the port.
802.1p Priority Select a priority level (0-7) to which the Switch changes the priority in outgoing IGMP
control packets. Otherwise, select No-Change to not replace the priority.
IGMP Filtering Select Active to enable IGMP filtering to control which IGMP groups a subscriber on a port
can join.
If you enable IGMP filtering, you must create and assign IGMP filtering profiles for the
ports that you want to allow to join multicast groups.
Unknown Specify the action to perform when the Switch receives an unknown multicast frame.
Multicast Frame Select Drop to discard the frame(s). Select Flooding to send the frame(s) to all ports.
Reserved The IP address range of 224.0.0.0 to 224.0.0.255 are reserved for multicasting on the
Multicast Group local network only. For example, 224.0.0.1 is for all hosts on a local network segment and
224.0.0.9 is used to send RIP routing information to all RIP v2 routers on the same
network segment. A multicast router will not forward a packet with the destination IP
address within this range to other networks. See the IANA web site for more information.
The layer-2 multicast MAC addresses used by Cisco layer-2 protocols,
01:00:0C:CC:CC:CC and 01:00:0C:CC:CC:CD, are also included in this group.
Specify the action to perform when the Switch receives a frame with a reserved multicast
address. Select Drop to discard the frame(s). Select Flooding to send the frame(s) to all
ports.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Immed. Leave Select this option to set the Switch to remove this port from the multicast tree when an
IGMP version 2 leave message is received on this port.
Select this option if there is only one host connected to this port.
Normal Leave Enter an IGMP normal leave timeout value (from 200 to 6,348,800) in miliseconds. Select
this option to have the Switch use this timeout to update the forwarding table for the port.
In normal leave mode, when the Switch receives an IGMP leave message from a host on a
port, it forwards the message to the multicast router. The multicast router then sends out
an IGMP Group-Specific Query (GSQ) message to determine whether other hosts
connected to the port should remain in the specific multicast group. The Switch forwards
the query message to all hosts connected to the port and waits for IGMP reports from
hosts to update the forwarding table.
This defines how many seconds the Switch waits for an IGMP report before removing an
IGMP snooping membership entry when an IGMP leave message is received on this port
from a host.
Chapter 24 Multicast
XS1920 Series User's Guide
184