ZyXEL Communications XS1920 Series User Manual page 27

The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is
3
functioning properly.
Close the transceiver's latch (latch styles vary).
4
Connect the fiber optic cables to the transceiver.
5
Figure 8 Transceiver Installation Example
Figure 9 Connecting the Fiber Optic Cables
3.1.2.2 Transceiver Removal
Use the following steps to remove a mini-GBIC transceiver (SFP+ module).
Remove the fiber optic cables from the transceiver.
1
Open the transceiver's latch (latch styles vary).
2
Pull the transceiver out of the slot.
3
Figure 10 Removing the Fiber Optic Cables
Figure 11 Opening the Transceiver's Latch Example
Figure 12 Transceiver Removal Example
Chapter 3 Hardware Panels
XS1920 Series User's Guide
27