The Installation Menu - Sony VPL-CH375 Operating Instructions Manual

The Installation Menu

The Installation menu is used for installing the projector.
Items
Screen Fitting
*1
V Keystone
*1
H Keystone
*1
Corner Keystone
Image Flip
Installation Attitude Link to Image Flip/Right Side Up/Upside Down: Change the cooling
High Altitude Mode On/Off: Set to "On" when using the projector at an altitude of 1,500 m or
*2
Panel Alignment
*3
Color Matching
Notes
*1: Since the HV Keystone/Corner Keystone adjustment is an electronic correction, the image may
deteriorate.
V Keystone: Even when set to "Auto," you can adjust manually by the following steps.
34
The Installation Menu
Item descriptions
HV Keystone/ Corner Keystone: You can choose how to correct image
twist.
This is displayed when "HV Keystone" is selected in "Screen Fitting."
Auto/Manual: The higher the setting, the narrower the top of the projected
image. The lower the setting, the narrower the bottom of the projected
image.
This is displayed when "HV Keystone" is selected in "Screen Fitting."
The higher the setting, the narrower the right side of the projected image.
The lower the setting, the narrower the left side of the projected image.
This is displayed when "Corner Keystone" is selected in "Screen Fitting."
Adjust: Corrects image twist.
Reset: Resets the adjusted values to their default values.
HV/H/V/Off: Flips the projected image horizontally and/or vertically
according to the installation method.
setting to suit to the installation attitude. When set to "Link to Image Flip,"
the cooling setting changes based on the setting of "Image Flip."
Continuing to use the wrong setting may affect component reliability.
higher. Continuing to use the wrong setting may affect component
reliability.
This feature allows you to adjust the gaps in the color of characters or the
picture.
When set to "On," "Adjust Color" and "Pattern Color" can be assigned and
adjusted.
Adjust Item: Selects how to make adjustments from below.
Shift: Shifts the whole picture and makes adjustments.
Zone: Selects the desired range and makes adjustments.
Adjust Color: Assigns the desired color to adjust the gaps in color. Select
"R" (Red) or "B" (Blue) to make adjustments based on "G" (Green).
Pattern Color: Select "R/G" (Red and Green) or "R/G/B" (White, all
colors) when "Adjust Color" is "R" (Red). Select "B/G" (Blue and Green)
or "R/G/B" (White, all colors) when the "Adjust Color" is "B" (Blue).
Adjust: The shift adjustment and zone adjustment of the color selected in
"Adjust Color" can be made with V/v/B/b keys.
Reset: The panel alignment settings are initialized to their factory preset
values.
Adjust/Reset: For correcting the brightness and color of the whole
projected image manually from the signal level in six steps.