The Operation Menu - Sony VPL-CH375 Operating Instructions Manual

The Operation Menu

The Operation menu is used for setting for the operations by using the menu or the Remote
Commander.
Setting items
Language
Menu Position
Status
IR Receiver
*1
Security Lock
Control Key
Lock
Note
*1: You will not be able to use the projector if you forget your password. If you call qualified Sony
personnel because you have forgotten the password, you will be asked to verify the projector's
serial number and your identity. (This process may differ in other countries/regions.) Once your
identity has been confirmed, we will provide you with the password.
30
The Operation Menu
Description
Selects the language used in the menu and on-screen displays.
Bottom Left/Center: For selecting the position of the menu displayed on the
projected image.
On: All on-screen statuses are enabled.
Off: Displays only the menus, the message when turning off the power, and
warning messages.
Front & Rear/Front/Rear: Selects the remote control detectors (IR Receiver)
on the front and rear of the projector.
On/Off: This function enables restriction of the projector to authorized users
by password. The setting procedures for security locking are as follows:
1 Select "On" then press the ENTER key to display the setting menu.
2 Input the password with the MENU, V/v/B/b, and ENTER keys. (The
default password setting is "ENTER, ENTER, ENTER, ENTER.")
3 Input a new password with the MENU, V/v/B/b, and ENTER keys.
4 Enter the password again to confirm.
Enter the password when you turn on the projector after disconnecting and
reconnecting the AC power cord.
When it is set to "Off," you can cancel the security lock. You are required to
input the password again.
If you fail to enter the correct password after three consecutive times, the
projector cannot be used. In this case, press the ?/1 key to go standby mode
then turn on the power again.
On/Off: When set to "On," locks all the control panel keys of the projector.
However, you can operate the following when set to "On":
• Press and hold the ?/1 key for approximately 10 seconds during Standby
mode.
c The projector turns on.
• Press and hold the MENU key for approximately 10 seconds during power
on.
c "Control Key Lock" is set to "Off" and enables operation of all keys on
the projector.