The Screen Menu - Sony VPL-CH375 Operating Instructions Manual

The Screen Menu

The Screen menu is used to adjust the size, position and aspect ratio of the projected image for
each input signal.
Items
*1
Aspect
When the computer
signal is input
When the video signal
is input
Adjust Signal
*2 *3
APA
*2
Phase
*2 *5
Pitch
*4
Shift
Notes
*1: • Note that if the projector is used for profit or for public viewing, modifying the original picture
by switching to the aspect mode may constitute an infringement of the rights of authors or
producers, which are legally protected.
• Depending on the input signal, setting items for aspect ratio or some other setting items cannot
be set in some cases, or changing the aspect ratio setting may have no effect.
26
The Screen Menu
Item descriptions
Changes the aspect ratio of the projected image (page 28).
4:3: Displays the image to fit the maximum projected image size
with an aspect ratio fixed to 4:3.
16:9: Displays the image to fit the maximum projected image size
with an aspect ratio fixed to 16:9.
Full 1: Displays the image to fit the maximum projected image
size without changing the aspect ratio of the input signal.
Full 2: Displays the image to fit the maximum projected image
size changing the aspect ratio of the input signal.
Full 3: Displays the image to fit the maximum width or height, up
to 1920 × 1080 pixels, without changing the aspect ratio of the
input signal.
Normal: Displays the image on the center position of the
projected screen without changing the resolution of the input
signal or enlarging the image.
4:3: Displays the image to fit the maximum projected image size
with an aspect ratio fixed to 4:3.
16:9: Displays the image to fit the maximum projected image size
with an aspect ratio fixed to 16:9.
Full: Displays the image to fit the maximum projected image size
changing the aspect ratio of the input signal.
Zoom: Zooms the center area of a projected image.
Adjusts the image of computer signal. Use this item if the edge of
the image is cut and reception is bad.
Automatically adjusts the projected image to an optimum quality
when you press the ENTER key (page 7).
Adjusts the dot phase of the display pixel and the input signal. Set
to the value where looks clearest.
The higher the value, the wider the horizontal image elements
(pitch). The lower the value, the narrower the horizontal image
elements (pitch).
H (Horizontal): The higher the value, the farther right the image
is projected on the screen. The lower the value, the image farther
left.
V (Vertical): The higher the value, the farther up the image is
projected on the screen. The lower the value, the image farther
down.