IBM eServer xSeries x382 Hardware Maintenance Manual And Troubleshooting Manual page 95

Table 16. Error codes/messages (continued)
Error code
8306 (OS boot watchdog timer
failure)
84F3 (BMC in Update Mode)
84FF (System event log full)
8500 (Multi-bit error detected in row
1. Row 1 mapped out)
8501 (Multi-bit error detected in row
2. Row 2 mapped out)
8504 (Persistent single-bit error
detected Row 1. Row 1 mapped
out)
8505 (Persistent single-bit error
detected in row 2. Row 2 mapped
out)
8508 (Memory mismatch detected
in row 1. Row 1 mapped out
8509 (Memory mismatch detected
in row 2. Row 2 mapped out)
850C (DIMM 1 defective)
850D (DIMM 2 defective)
850E (DIMM 3 defective)
850F (DIMM 4 defective)
8510 (DIMM 5 defective)
8511 (DIMM 6 defective)
8512 (DIMM 7 defective)
8513 (DIMM 8 defective)
FRU/action
Yes System exceeded 6-minute watchdog timer on boot
cycle. Refer to "Watch dog timer" for details.
Yes Check to see that the jumper at J5H4 is in position 1-2
=normal, (position 2-3 is update mode).If Issue persists
replace Minipark.
Yes The System Event Log is Full, Save or Clear SEL, See
section on "Thresholding"
Yes The multi-bit error is detected on a DIMM(s) in Row 1;
Row disabled, Refer to "Memory" in Debug Methodology
and FRU Isolation section.
Yes The multi-bit error is detected on a DIMM(s) in Row 2;
Row disabled, Refer to "Memory" in Debug Methodology
and FRU Isolation section.
Yes Issue with DIMM address or data line likely affecting
multiple DIMMs (otherwise ECC should recover) in Row
1; Row disabled, Refer to "Memory" in Debug
Methodology and FRU Isolation section.
Yes Issue with DIMM address or data line likely affecting
multiple DIMMs (otherwise ECC should recover) in Row
2; Row disabled, Refer to "Memory" in Debug
Methodology and FRU Isolation section.
Yes Issue with DIMM SPD value in Row 1; Row disabled,
Refer to "Memory" in Debug Methodology and FRU
Isolation section.
Yes Issue with DIMM SPD value in Row 2; Row disabled,
Refer to "Memory" in Debug Methodology and FRU
Isolation section.
Yes Issue with DIMM 1=J9J3, Refer to "Memory" in Debug
Methodology and FRU Isolation section.
Yes Issue with DIMM 2=J9J1, Refer to "Memory" in Debug
Methodology and FRU Isolation section.
Yes Issue with DIMM 3=J9D3, See memory in Debug
Methodology and FRU Isolation section.
Yes Issue with DIMM 4=J9D1, See memory in Debug
Methodology and FRU Isolation section.
Yes Issue with DIMM 5=J9J2, See memory in Debug
Methodology and FRU Isolation section.
Yes Issue with DIMM 6=J8J1, See memory in Debug
Methodology and FRU Isolation section.
Yes Issue with DIMM 7=J9J2, See memory in Debug
Methodology and FRU Isolation section.
Yes Issue with DIMM 8=J8D1, See memory in Debug
Methodology and FRU Isolation section.
Chapter 6. Symptom-to-FRU index
85