Table of Contents
Advertisement
Complete the following steps to replace the power supply bay:
1. Remove the hot-swap power supplies from the power supply bay.
2. Slide the power supply bay in from the front of the server.
3. Align and tighten the three retention screws at the rear of the power supply
bay.
4. Replace the two screws on top of the power supply bay.
5. Slide the Electronics bay toward the rear of the chassis as far as it will go;
then, tighten the two screws at the rear of the chassis to secure the
Electronics bay.
6. Place the peripheral bay assembly on top of the power supply bay and slide
the peripheral bay toward the rear of the server as far as it will go; then,
tighten the retaining screw at the rear of the peripheral bay to secure it.
7. Reconnect all cables that were disconnected.
8. Reinstall the fan assembly.
9. Reattach the cable management plate to the fan assembly.
10. Install the fans in the fan bay. Align the two tabs on the replacement fan with
the notches in the server and press the fan into the corresponding connector.
Press the fan firmly to engage the latch fully and secure the fan in the server.
11. Reinstall the power supplies.
12. Replace the cover (see "Cover removal and replacement" on page 49).
Chapter 5. Service replaceable units
69
Advertisement
Table of Contents
