Table of Contents
Advertisement
The following illustration shows how to install the PCI riser in the server.
Complete the following steps to replace the PCI riser assembly:
1. Place the PCI riser assembly release lever is in the extended position.
2. Insert the PCI riser assembly into the guides and press it down toward the
system board until it stops.
3. Attention:
To prevent damage to the PCI riser assembly connector and
system board connector, ensure that the four corners of the PCI riser assembly
are parallel to the system board and the connector on the PCI riser assembly
and system board are aligned before and while rotating the release lever.
Rotate the PCI riser assembly release lever in small 30 degree increments
stopping periodically to adjust the corners of the assembly to ensure that the
assembly is parallel to the system board. A full 90 degree rotation of the release
lever is required.
Rotate the PCI riser assembly release lever toward the front of the server until it
stops.
4. Connect any internal cables that are required for optional adapters. Route
cables so that they do not block the flow of air from the fans.
5. Replace the cover (see "Cover removal and replacement" on page 49.
PCI riser assembly
PCI riser release
lever
Chapter 5. Service replaceable units
59
Advertisement
Table of Contents
