7. Press the fan-release latch in the direction indicated by the arrow.
8. Pull the fan out of the server.
9. Align the two tabs on the replacement fan with the notches in the server and
press the fan into the corresponding connector. Press the fan firmly to engage
the latch fully and secure the fan in the server.
10. If the server is turned on, verify that the new fan is running and that its failure
LED is not lit. If the fan is not running or if its failure LED is lit, reseat the fan.
11. Replace the cover (see "Cover removal and replacement" on page 49).
Fan status LED
Chapter 5. Service replaceable units
53