IBM eServer xSeries x382 Hardware Maintenance Manual And Troubleshooting Manual page 92

Table 16. Error codes/messages (continued)
Error code
140 (PCI error)
141 (PCI memory allocation error)
142 (PCI IO allocation error)
143 (PCI IRQ allocation error)
0144 (Shadow of PCI ROM failed)
145 (PCI ROM not found)
146 (Insufficient memory to shadow
PCI ROM)
8100 (Microprocessor 01 failed
BIST)
82
IBM eServer xSeries x382 Type 8834: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
Yes
1. Check the PCI riser card connectors for pin damage.
2. Reseat the PCI adapters and retest the server.
Note: The PCI riser card contains core logic and must
be installed to boot the server.
3. Replace the riser card.
4. Replace the system board.
Yes.
1. Memory allocation area for PCI device exceeded.
Remove any add-in PCI adapters and retest the
server.
2. Replace any PCI add-in adapters
3. Replace the PCI riser card.
4. Replace the system board.
Yes
1. PCI IO resource allocation for PCI device has been
exceeded. Remove any add-in PCI adapters and
retest the server.
2. Replace any PCI add-in adapters
3. Replace the PCI riser card.
4. Replace the system board.
Yes
1. PCI IRQ allocation for PCI devices has been
exceeded. Remove any add-in PCI adapters and
retest the server.
2. Replace any PCI add-in adapters
3. Replace the PCI riser card.
4. Replace the system board.
Yes
1. PCI ROM memory allocation area for PCI devices has
been exceeded. Remove any add-in PCI adapters and
retest the server.
2. Replace any PCI add-in adapters
3. Replace the PCI riser card.
4. Replace the system board.
Yes
1. PCI ROM memory allocation area for PCI devices has
been exceeded or PCI ROM did not have space to
load. Remove any add-in PCI adapters and retest the
server.
2. Replace any PCI add-in adapters
3. Replace the PCI riser card.
4. Replace the system board.
Yes
1. PCI ROM area exceeded. Remove any add-in PCI
adapters and retest the server.
2. Replace any PCI add-in adapters
3. Replace the PCI riser card.
4. Replace the system board.
Microprocessor failed to initialize in time, Refer to "Fault
Yes
Resilient Boot" in Debug Methodology and FRU Isolation
section.