IBM eServer xSeries x382 Hardware Maintenance Manual And Troubleshooting Manual page 93

Table 16. Error codes/messages (continued)
Error code
8101 (Microprocessor 02 failed
BIST)
8110 (Microprocessor 01 internal
error (IERR)
8111 (Microprocessor 02 internal
error (IERR)
8120 (Microprocessor 01: Thermal
trip failure)
8121 (Microprocessor 02: Thermal
trip failure)
8130 (Microprocessor 01 disabled)
8131 (Microprocessor 02 disabled)
8140 (Microprocessor 01 failed FRB
level 3 timer)
8141 (Microprocessor 02 failed FRB
level 3 timer)
8150 (Microprocessor 01 failed
initialization on last boot)
8151 (Microprocessor 02 Failed
initialization on last boot)
FRU/action
Microprocessor failed to initialize in time, Refer to "Fault
Yes
Resilient Boot" in Debug Methodology and FRU Isolation
section.
Refer to "Microprocessor" in Debug Methodology and
Yes
FRU Isolation section. .
Refer to "Microprocessor" in Debug Methodology and
Yes
FRU Isolation section.
Yes Microprocessor 01 has exceeded the thermal diode
temperature limit resulting in a thermal trip event, check
for airflow obstructions to fans & heat sinks. Ensure
processor air duct is present and secured. The system
is designed to run heavy loads up to 35C or 96F
ambient. However, Under normal (i.e. no fan failure)
conditions, the CPU should not throttle until 42C/ 107F.
(With a fan failure, throttling could possibly occur at
about 27C) Thermal trip should occur at 50C /120F,
thermal trip will shut down the processor or system. If
this occurs and the ambient temp is far cooler - Refer to
"Microprocessor" in Debug Methodology and FRU
Isolation section .
Yes Microprocessor 02 has exceeded the thermal diode
temperature limit resulting in a thermal trip event, check
for airflow obstructions to fans & heat sinks. Ensure
processor air duct is present and secured. The system
is designed to run heavy loads up to 35C or 96F
ambient. However, Under normal (i.e. no fan failure)
conditions, the CPU should not throttle until 42C/ 107F.
(With a fan failure, throttling could possibly occur at
about 27C) Thermal trip should occur at 50C /120F,
thermal trip will shut down the processor or system. If
this occurs and the ambient temp is far cooler - Refer to
"Microprocessor" in Debug Methodology and FRU
Isolation section.
Yes Microprocessor failed to initialize in time, Refer to Refer
to "Fault Resilient Boot" in Debug Methodology and FRU
Isolation section.
Yes Microprocessor failed to initialize in time, Refer to Refer
to "Fault Resilient Boot" in Debug Methodology and FRU
Isolation section.
Yes Microprocessor failed: Fault Resilient Boot Timer (FRB)
expired. Refer to Refer to "Fault Resilient Boot" in Debug
Methodology and FRU Isolation section.
Yes Microprocessor failed: Fault Resilient Boot Timer (FRB)
expired. Refer to Refer to "Fault Resilient Boot" in Debug
Methodology and FRU Isolation section.
Yes Microprocessor failed to initialize in time, Refer to Refer
to "Fault Resilient Boot" in Debug Methodology and FRU
Isolation section.
Yes Microprocessor failed to initialize in time, Refer to Refer
to "Fault Resilient Boot" in Debug Methodology and FRU
Isolation section.
Chapter 6. Symptom-to-FRU index
83