Canon LBP-860 Service Manual page 128

2. Removing the paper feeder pick-up
motor
1) Kemove the drive unit.
2) Remove the four screws, the E-ring, the
gear, and remove the plate.
Screws
Figure 5-77
3) Remove the Iwo screws and remove the
pick-up motor.
Screws
Download Service Manual and Resetter Printer at http://printer1.blogspot.com
Removing the paper feeder driver
PCB
Remove the screw. release the two
claws, and open lhe PCB cover.
Fig. 3-75.)
Disconnect the three connectors and
remove the cable tie.
Release the claw holding the PCB, then
lift the paper feeder driver PCB.
Figure
4. Removing the paper feeder pick-up
roller
Pull out the pick-up roller by its knob.
Figure 3-80
[See