Electronic Appliance Inspection - Superior DRT6340TYN Installation And Operation Instructions Manual

Superior drt/drc6300 series powervent direct vent gas fireplaces

Hide thumbs Also See for DRT6340TYN:

Care and operation instructions manual (28 pages)

Supplemental instructions (2 pages)

Table Of Contents

Table of Contents

INNOVATIVE HEARTH PRODUCTS • POWER VENT DV GAS FIREPLACES (DRT6340/45TYN) • INSTALLATION INSTRUCTIONS

Burner Air Shutter Adjustment Procedure

WARNING

• Air shutter adjustment should

only be performed by a quali-

fied professional service tech-

nician.

• Ensure that the front glass door

assembly is in place and sealed

After adjustment.

CAUTION

Soot will be produced if the

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

air shutter is closed too much.

Any damage due to carboning

resulting from improperly setting

the air shutter is not covered

under the warranty.

The following paragraphs address burner

adjustment concerns and procedures.

When lit for the first time, this appliance will emit

a slight odor for an hour or two. This is due to

the "burn-in" of internal paints and lubricants

used in the manufacturing process.

Adjustment

To adjust the flame, move the adjustment air

shutter (located on the lower venturi) back or

forward to increase or reduce the air shutter

opening, respectively. Position the air shut-

ter to the factory setting as shown in Table

8. Allow the burner to operate for at least 15

minutes. Observe the flame continuously. If it

appears weak or sooty as previously described,

adjust the air shutter until the flame appearance

is as desired.

When satisfied that the appliance operates

properly, leave the wall ON/REMOTE/OFF

switch in REMOTE position and turn the remote

switch OFF.

Air Shutter

Opening

Venturi

Orifice

Gas Valve

Burner

Venturi

Model

Natural Gas

40 in.

1/8" (3.18 mm)

45 in.

1/8" (3.18 mm)

Table 18 - Main Burner Factory Air

Shutter Opening Setting

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.