Side To Side Registration Adjustment - Ricoh A095 Service Manual

6.10 SIDE TO SIDE REGISTRATION ADJUSTMENT

[D]
5 ± 2 mm
1. Remove the small cover at the rear side on the upper DJF cover.
2. Turn on DIP SW 101-2 and 101-4.
3. Set a sheet of A4 / 8 1/2" x 11" (53 ~ 80 g/m
paper on the original table.
4. Push SW 101 [A].
5. After the original stops on the exposure glass, gently raise the DJF so
that the original does not move.
6. Confirm that if the gap between the rear edge of the paper and the
original rear scale is 5 ±2 mm.
7. If the gap is not within the specification, adjust the registration by using
copier's SP mode (
8. It the gap is not within specification by using SP mode, loosen the eight
screws fixing the original table [B] and the original guide [C] and shift the
original table and the original guide position accordingly.
NOTE: Before setting the original on the original table again, open and
close the feed unit cover [D].
FSM
SP Adjustment - PAGE 4).
1
7-31
[A]
[C]
/ 14 ~ 22 lb) sideways
2
A095/A096/A097
[B]