Ricoh A095 Service Manual page 426

[B]
3. Install the cover [A] with a screw supplied as an accessory of the copier.
4. Install four stepped screws (front: M4, rear: M5 minus screw) [B] to hook
the RDH.
NOTE: There is one screw hole available on the left side for one of the
stepped screws. However there are two screw holes available
on the right where the stepped screw is to be installed.
Install the stepped screw into the outer screw hole [C] as shown
in the illustration.
5. Mount the RDH to the two stepped screws [D] by aligning the holes in
the RDH hinge [E] and the stepped screws, then slide the RDH to the
right as shown.
FSM
[A]
[E]
[D]
9-7
[B]
[C]
A095/A096/A097