Ricoh A095 Service Manual page 416

- Alignment of the 3 Helical Wheels -
[B]
[A]
[C]
1. Confirm all belts are set correctly.
2. Align all holes [A] at the middle of the helical wheels at the center of the
bin guide slots [B], as shown.
3. In this condition, tighten all Allen screws [C] on the helical wheel drive
pulleys (2 Allen screws on each drive pulley).
4. In this condition, place the cut out [D] on the wheel sensor actuator under
the wheel sensor [E] then tighten the Allen screw on the wheel sensor
actuator.
FSM
[A]
[D]
[E]
[C]
8-33
[C]
A095/A096/A097