1.2 REAR SIDE
[A]
1.2.1 Upper Rear Cover
1. Turn off the main switch.
2. If the DJF or RDH is installed, disconnect the fiber optics connectors [A]
and [B].
NOTE: After the upper rear cover is re-installed, set the fiber optics
connectors [A] and [B] so that the fiber optic cable [A] is located
over the electrical cable [B]. Also, the fiber optic cable [A]
should not bend while opening and closing the DJF or RDH.
3. Remove the upper rear cover [C]. (4 screws)
1.2.2 Lower Rear Cover
1. Remove the lower rear cover [D]. (6 screws)
NOTE: When installing the lower rear cover, set the hooks in the holes
on the right and left side covers.
A095/A096/A097
[B]
[C]
[D]
5-2
FSM