Network Routing Check; Restrictions On The Use Of Lan2 - Sony Ipela PCS-XG80S Operating Instructions Manual

Network Routing Check

The Network Routing Check menu is used to
check the network routing, and it shows the
checking results.
You can start the network routing check by
selecting "Start Measurement" in the lower
part of the menu.
For details, see "About the Network Routing
Check" on page 105.
IP address of remote site
Enter the IP address of the remote terminal
you want to check.
Line I/F
LAN1: Select to perform the routing check
for the network connected to the
connector.
LAN2: Select to perform the routing check
for the network connected to the
connector.
Gateway
Displays the results of check for the default
gateway.
ping
Displays the results of check for
reachability, packet loss, RTT (Round-Trip
Time) and H.323 (H.323 communication
availability).
traceroute
Displays the results of check for HOP
(number of routers passed through to reach
the remote site) and total RTT.
Start Measurement
Select this button to start a network routing
check.
Previous
Select this button to restore the Machine
Status menu.
Restrictions on the
Use of LAN2
When you use two LAN connections, use
the 1 (LAN1) connector to connect a
private network in your company and the
2 (LAN2) connector to connect to an
intranet outside your company.
The following functions of the system are
restricted when using the
connector.
Note
In the event of using the
connector to connect to an intranet outside your
company, make sure to set "Web Access",
1
"Telnet Access" and "SSH Access" to
"Disabled" on the Access Permit page of the
Administrator setup menu (page 87).
2
Items that cannot be set with LAN2
• NAT Mode
• Gatekeeper
• SNMP Mode
• SIP
• NTP
• Shared Phone Book
• AMX Device Discovery
• H.460
• DNS
• Streaming
• IPv6
• Web Access, Telnet Access, SSH Access
Item that can be set with either
LAN1 or LAN2
• PPPoE
Items to be set with LAN1 or LAN2
individually
• DHCP Mode
• IP Address
• Network Mask
• Gateway Address
• LAN Mode

Restrictions on the Use of LAN2

2 (LAN2)
1 (LAN1)
95