Switching The Broadcast Mode - Sony Ipela PCS-XG80S Operating Instructions Manual

Switching the Broadcast Mode

At the beginning of the connection, the broadcast mode set in "Broadcast
Mode" and "Split" of the Multipoint setup menu is applied. You can change
the mode during communication using the Layout menu.
Note
If "Broadcast Mode" of the Multipoint setup menu is set to "Voice Activate (720P)",
you cannot switch "Broadcast Mode" during communication as the "Broadcast Mode"
does not appear in the Layout menu. Set "Broadcast Mode" before starting
communication.
1
Press the LAYOUT button on the Remote Commander.
The Layout menu appears.
2
Use the V, v, B or b button on the Remote Commander to select the mode
to which you want to switch from "Broadcast Mode", then press the
ENTER button.
Layout
Screen Display Patterns
Monitor Select Mode
Broadcast Mode
Split
Split: Selects the Split mode.
Split (A fixed): Fixes the picture of the terminal connected first in the
specified window of the fixed split mode.
Split (B fixed): Fixes the picture of the terminal connected second in the
specified window of the fixed split mode.
Split (C fixed): Fixes the picture of the terminal connected third in the
specified window of the fixed split mode.
Split (D fixed): Fixes the picture of the terminal connected fourth in the
specified window of the fixed split mode.
204
Using the Display Control
Full PandP
PinP PinP
HDMI RGB
Side by Side PinP
PinP PinP
HDMI+RGB
Terminal
0
Save Cancel