Tos Setup Menu - Sony Ipela PCS-XG80S Operating Instructions Manual

TCP Port Number
Enter the fixed TCP port number.
UDP Port Number
Enter the fixed UDP port number.
For details on the port numbers used on the
system, see "List of Port Numbers Used on
the PCS-XG80/XG80S" on page 246.
Packet Resend Request (ARQ)
Allows you to select whether to request
packet to be resent when packet losses occur
during communication.
On: Requests packets to be resent.
Off: Does not request packets to be resent.
Note
When a multipoint connection is made among
six points with "Packet Resend Request
(ARQ)" set to "On", the maximum bandwidth
to be used is restricted to 7 Mbps.
ARQ Buffering Time
Set the buffering time used for "Packet
Resend Request".
You can select from among "300ms",
"150ms", "80ms", "Auto" and "Custom".
When "Custom" is selected, you can specify
any buffering time.
ARQ Buffering Time
Enter the buffering time (50 ms to 999 ms)
when you select "Custom" in "ARQ
Buffering Time".
Forward Error Correction (FEC)
Allows you to select whether received
packets are identified with an error
correction mark.
On: Identifies with an error correction mark.
Off: Not identify with an error correction
mark.
Note
When "Forward Error Correction (FEC)" is set
to "On", the maximum bandwidth to be used is
restricted to 8 Mbps.
FEC Redundancy
Allows you to set redundancy of the packet
used for the Forward Error Correction
(FEC).
You can select from among "8", "4", "2" and
"Auto". When you select "8", "4" and "2",
the communication bit rate may be different
from the specified value.
Audio Duplex Transmission
Allows you to select whether to
automatically transmit audio in double when
audio communication is interrupted
depending on a network status.
On: Enables the Audio Duplex
Transmission feature.
Off: Disables the Audio Duplex
Transmission feature.
QoS2
Re-Order/Shaping
Re-Order
Allows you to select whether to correct re-
order that may cause packet loss (invalid
order of arrival in the packet). Correcting re-
order enables smoother picture and sound.
On: Corrects re-order.
Off: Does not correct re-order.
Re-Order Buffer
Allows you to select re-order buffer.
You can select from among "Auto", "1",
"2" and "Custom".
Re-Order Buffer Rate
Enter the re-order buffer rate. You can enter
the value between 1 and 5.
Shaping
Allows you to select whether to use shaping,
which adjusts the IP packet transfer rate.
On: Uses shaping.
Off: Does not use shaping.
.

TOS Setup Menu

TOS
TOS
TOS Data Type
Allows you to select the type of data for
which you configure the TOS (Type of
Service) field.
Video: Configure the TOS field for video
data.
Registering Local Information
77