Remote Power - Extron electronics XTP T USW 103 User Manual

Remote power

The XTP T USW 103 can be powered remotely through an XTP Power Injector or through
an XTP matrix switcher.
ATTENTION: XTP remote power is intended for indoor use only. No part of the network
that uses XTP remote power should be routed outdoors.
Power injector
To power the XTP T USW 103 remotely with an XTP Power Injector, power one device
Local power
locally (see on page 8) and connect an XTP Power Injector to the XTP cable
run along the XTP ports (see the XTP Power Injector User Guide for more installation
information).
NOTE: The power injector provides remote power up to 330 feet with a shielded twisted
pair cable with 24 AWG wire.
POWER 2
1
12V
AUDIO
1.0 A MAX
RGB HDMI
INPUTS
Extron
XTP T USW 103
XTP Transmitter
100-240V 50/60 Hz
Power ---A MAX
Extron
XTP PI 100
XTP Power
Injector
POWER
12V
1A MAX
Extron
12V Local Power
XTP R HDMI
Supply
XTP Receiver
Figure 9. Typical Pont-to-point Application with Remote Power
Remote power from an XTP matrix switcher
XTP matrix switchers have a fixed amount of power available to provide remote power
to connected XTP devices (see the XTP matrix switcher user guide for more details). To
manage available power from the XTP matrix switcher, use the XTP System Configuration
Software with the XTP matrix switcher (see
page 19).
OVER XTP REMOTE
SIG LINK
3
RS-232 IR CONTACT RS-232
R
HDMI XTP OUT
LAN
Tx Rx G Tx Rx 1 2 3 G Tx Rx G
Remote
Power
XTP XTP PWR
PWR
Shielded Twisted
Pair Cable
SIG LINK OVER XTP
AUDIO
RS-232 IR
ON
OFF
XTP IN
LAN Tx Rx G Tx Rx HDMI
XTP System Configuration Software
XTP T USW 103 Switcher • Installation
XTP R HDMI
RELAYS
OUTPUTS
AUDIO
L R 1 2
RESET
+ − + − S/PDIF
on
9