Extron electronics XTP T USW 103 User Manual page 31

Input/Output tab
Click the tab (see figure 22,
Input/Output
input information and options to apply automatic settings to individual inputs.
Figure 22. Input/Output Tab
Input Name— Displays the input name.
2
Signal Type — Displays the signal type of each input. Input 1 is
3
are .
HDMI/DVI
Auto-Image — Attempts to size and center the input signal based on the aspect ratio
4
setting. Auto-Image is applied whenever there is a change in the input sync.
Auto Memory — Recalls input and image settings for signals that have previously been
5
applied. When it is disabled, the XTP T USW 103 treats every newly applied input as a
new source.
HDCP Authorized — Select either
6
report as an HDCP authorized device. If the box is not checked, the source is blocked
from encrypting its output. This may result in some content not being passed by the
source device.
NOTE: HDCP authorization is for inputs 2 and 3 only.
XTP T USW 103 Switcher • XTP System Configuration Software
) to open the Input/Output screen. It contains
1
check box to have the input
HDCP Authorized
. Inputs 2 and 3
analog
25