Interface Settings/Parallel Interface - Lanier 5622 AG Operator's Manual

Interface Settings/Parallel Interface

❖ ❖ ❖ ❖ Parallel Timing
Specifies the timing setting for the parallel interface. Under normal circum-
stances, you will not need to change this setting.
Note
❒ Default: ACK outside
❖ ❖ ❖ ❖ Parallel Communication Speed
Specifies the communication speed for the parallel interface. If the communi-
cation speed is set too fast, data transfers may not flow smoothly. If this oc-
curs, change the setting to "Standard".
Note
❒ Default: High speed
❖ ❖ ❖ ❖ Selection Signal Status
Specifies the level for the select signal setting of the parallel interface.
Note
❒ Default: High
❖ ❖ ❖ ❖ Input Prime
Specifies whether the prime signal is active or inactive when an input prime
signal is sent. Under normal circumstances, you will not need to change this
setting.
Note
❒ Default: Invalid
❖ ❖ ❖ ❖ Bidirectional Communication
Specifies the printer's response mode and so forth for a status request when
using the parallel interface. If you experience problems when using other
manufacturers printers, set this to "Off". However, if this is set to "Off", asyn-
chronous functions will not work.
Note
❒ Default: Yes
❖ ❖ ❖ ❖ Signal Control
Specifies the error processing settings for when an error occurs when printing
from a computer or sending faxes. Under normal circumstances, you will not
need to change this setting.
Note
❒ Default: Job acceptance priority
Settings You Can Change with the User Tools
4
81