Covers, Operator Panel Assembly Removal - Lexmark 248X-200 series Service Manual

24XX-200

Covers, operator panel assembly removal

1. Remove the top cover. Go to
page 4-8.
2. Disconnect the operator panel cable from the operator panel
card on the inside of the top cover.
3. Push down on the two latches (A) at the top of the operator
panel on the inside of the top cover, as shown.
4. While holding the latches down, push the operator panel out of
the top cover, toward the bottom of the cover.
Note: During replacement, be sure the operator panel cable is
correctly inserted into both the operator panel card and the logic
board.
4-10
Service Manual
"Covers, top removal" on