Printer Speeds; Setup Mode; Entering Setup Mode; Exiting Setup Mode - Lexmark 248X-200 series Service Manual

24XX-200

Printer speeds

Fast draft
Draft
NLQ—
Near
Letter Quality
cpi = characters per inch
cps = characters per second

Setup mode

Entering Setup mode

1. Open the operator panel cover to access layer two.
2. Press Setup to put the printer in Setup mode and print the Main
Menu.
3. Press LineFeed to print a list of all the available options.
4. Select any option from the Main Menu by pressing the
corresponding button. A new menu prints each time you press a
button, displaying new selections.
5. After making a selection, the printer prints a page with the
changes shown.

Exiting Setup mode

1. Press Set TOF until the printer returns to the Main Menu, or
press Pitch from any menu containing a Return to Main Menu
selection.
2. Press Set TOF again to exit Setup mode. New settings are
saved only when the printer exits Setup mode.
Note: If the printer runs out of paper while in Setup mode, load
more paper into the tractor pins and press Setup to continue.
1-2
Service Manual
9 Wire
10 cpi
438 cps 510 cps
309 cps 304 cps
77.5 cps 77.5 cps
12 cpi 10 cpi
409 cps
274 cps
91.7 cps
24 Wire
12 cpi
465 cps
328 cps
109 cps