Lexmark 248X-200 series Service Manual page 102

24XX-200
9. Remove the two screws (A) securing the platen to the side
frames.
10. Remove the carrier motor bracket. Go to
assembly removal" on page
11. Remove the five screws securing the left side frame, and then
remove the frame.
12. Remove the four screws from the right side frame, and then
remove the bottom frame assembly.
13. Remove the five screws from the frame support plate, and then
remove the lower feed roller.
14. Be sure to perform the printhead-to-platen gap adjustment. Go
to "Printhead-to-platen gap adjustment" on page
4-40
Service Manual
"Carrier, motor
4-19.
4-2.