Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Eastwood 12740
Summary of Contents for Eastwood 12740
- Page 1 Part #12740 VERSA-CUT PLASMA CUTTER ASSEMBLY & OPERATING INSTRucTIONS...
-
Page 2: Specifications
STATEMENT OF LIMITED WARRANTY The Eastwood Company (hereinafter “Eastwood”) warrants to the end user (purchaser) of all new welding and cutting equipment (collectively called the “products”) that it will be free of defects in workmanship and material. This warranty is void if the equipment has been subjected to improper installation, improper care or abnormal operations. -
Page 3: Danger Warnings
This unit emits a powerful high voltage and extremely high temperature plasma arc of superheated air which can cause severe burns, dismemberment, electrical shock and death. Eastwood shall not be held liable for consequences due to deliberate or unintentional misuse of this product. -
Page 4: Required Items
You can even use a portable air tank with regulator. The air supply must be dry and the use of a moisture trap is strongly recommended. • Eastwood recommends at a minimum a properly grounded 110-120 VAC 50/60Hz., 20 Amp circuit or 220-240 VAC 50/60Hz., 30 Amp circuit. NOTE: Unit must be grounded to work properly and safely! •... - Page 5 • Attach the Ground Lead Connector to the terminal located at the lower right of the front panel. (Fig. C) FIG. C Pilot Arc Ground Ignitor Torch Air Torch Supply Line Switch Connector To order parts and supplies: 800.345.1178 >> eastwood.com...
-
Page 6: Operation
10. A good form of practice is to attempt a series of straight lines while creating the cleanest edge possible with a minimum of molten material remaining on the cut edge. This minimizes the cleanup of the edge with a grinder or file. Another excellent technique is to practice cutting your initials out of a piece of steel. Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com... -
Page 7: Care And Maintenance
• Always store the unit in a safe, clean and dry environment. TORch MAINTENANcE FIG. F The Eastwood Versa Cut Plasma Cutter has a number of consumable parts that will need to be replaced over time. If wear or slag build up is noticed on any of the torch components, replace them immediately to avoid damage to the torch. -
Page 8: Troubleshooting
• #13787 – External Nozzle • #13788 – Air Diffuser If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.544.5118 >> email: techelp@eastwood.com The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA US and Canada: 800.345.1178...