DuTY cYcLE The rated Duty Cycle refers to the amount of welding that can be done within an amount of time. The Eastwood Versa-Cut 60 Plasma Cutter has a duty cycle of 60% at 60 Amps. It is easiest to look at your cutting time in blocks of 10 Minutes and the Duty Cycle being a percentage of that 10 Minutes.
This unit emits a powerful high voltage and extremely high temperature plasma arc of superheated air which can cause severe burns, dismemberment, electrical shock and death. Eastwood shall not be held liable for consequences due to deliberate or unintentional misuse of this product.
POWER REquIREMENTS The Eastwood Versa-Cut Plasma Cutter is supplied with the popular NEMA 6-50P plug, requiring a NEMA 6-50R recepticle. BEFORE YOu BEGIN Remove all items from the box. Compare with list below to make sure unit is complete.
Page 5
• Attach the Ground Lead Connector to the terminal located at the lower right of the front panel. (Fig. C) Compressed Air Inlet FIG. C Pilot Arc Ground Ignitor Torch Air Torch Supply Line Switch Connector To order parts and supplies: 800.345.1178 >> eastwood.com...
Page 6
• Attach the Ground Lead Connector to the terminal located at the lower right of the front panel. (Fig. C) Compressed Air Inlet FIG. C Pilot Arc Ground Ignitor Torch Air Torch Supply Line Switch Connector To order parts and supplies: 800.345.1178 >> eastwood.com...
FIG. F environment. TORch MAINTENANcE The Eastwood Versa-Cut 60 Plasma Cutter has a number of consumable parts that will need to be replaced over time. If wear or slag build up is noticed on any of the torch components, External replace them immediately to avoid damage to the torch.
• #13788 – Air Diffuser If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.544.5118 >> email: techelp@eastwood.com PDF version of this manual is available online >> eastwood.com/14099manual The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA US and Canada: 800.345.1178...