Mix Output - E-Mu XK6Xtreme Keys Owner's Manual

Mix Output

   
Send Routings
Send 1 - Main Outputs
Send 2 - Subout 1 or Main Outs
Send 3 - Main Outs
Send 4 - Main Outputs
86 E-MU Systems
The Mix Output parameter allows you to override the routing assignments
made in each preset and instead assign the outputs according to MIDI
channel. For each of the 16 MIDI channels, you can select Send 1-4, or
Preset. When Preset is selected, the output assignment defined in the Preset
Edit menu is used.
MIX OUTPUT
channel 16: Send 1->main
The Output Routing field (pointed to by the arrow) reflects the true
routing of Send 2 or Send 3 to either:
1) the effects processor input or... 2) the rear panel submix jacks.
Since the Sub 1 output is NOT being used, the signal is routed through the
effects processors, then on to the main outputs. If a plug were inserted into
one of the Sub 1 jacks the destination field would read "Sub1" for Send 2
and the dry signal would be routed directly to the Sub 1 outputs on the
back panel.
MIX OUTPUT
channel 15: use preset
The Sends function as effect processor inputs (effect sends). Send 2 is also
used to route sounds to the Sub 1 outputs on the back panel. When a plug
is inserted into the associated Submix jack on the back panel, the Dry
portion of the Send is disconnected from the effects processor and the
signal is routed directly to the output jack. The Arrow points to the actual
output routing. If you don't want the wet portion of the signal in the main
mix, turn down the Send Level. The entire Send is disconnected from the Effects
Processors even if only one plug is inserted into the Submix jack.
The four Effect Sends allow you to get the most out of the two effect
processors. For example, with Effect B set to an echo algorithm, you could
route one MIDI channel to Send 3 and set the effect amount to 80%.
Another MIDI channel could be routed to Send 4 with an effect amount of
only 5%. This is almost like having two different effects!
The Mix Output function is also useful when sequencing since it lets you
route specific MIDI channels to specific Sub outputs (on the back panel)
where there they can be processed with EQ or other outboard effects.
Defining Global Parameters
Indicates that the dry signal is
routed to the Main output jacks.
Global Menu