Fxb Parameters; Fxb Send Amounts; Preset Patchcords - E-Mu XK6Xtreme Keys Owner's Manual

FXB Parameters

FXB Send Amounts

Preset Patchcords

O O O O
To crossfade between
effects.
1) Set FXA Send 1 to 100%.
2) Set FXB Send 1 to 0%.
3) Set FX Cord #1 to FXA Send 1
at -100.
4) Set FX Cord #2 to FXB Send 1
at +100.
Increasing the controller amount
will crossfade from FXA to FXB.
The FXB parameters are Feedback, LFO Rate and Delay. Feedback sends the
output of the effect back into the input. This creates multiple echoes on a
delay effect and intensifies a chorus or flange effect. LFO Rate allows you to
change the speed of the modulation oscillator for flange and chorus effects.
Delay sets the length of the delay line. This affects the time between
echoes, or the tone of flange effects.
FXB FEEDBK
These parameters set the effects amounts for the four stereo effects busses.
FXB SEND AMOUNTS
2: 50%
Preset PatchCords give you real-time control of global parameters. The
effect processors are a powerful synthesis tool and this feature lets you
control and use them in exciting new ways. For example, you can dynami-
cally adjust the effects mix during a sequence or live performance.
There are many exciting performance possibilities using Preset PatchCords
to control Arpeggiator parameters and Effects Sends. The front panel knobs
15 & 16 are usually connected to Arp parameters in factory presets marked
"arp:" Be sure to try out these controls
There are 12 Preset PatchCords per preset with a source, a destination and
an amount control. The amount can be set from -100 to +100. The Preset
PatchCord controls are added to the FX Send Amounts set in the Global or
Preset Edit menus. In other words, multiple sources connected to destina-
tions are summed.
PRESET CORDS
Pedal
LFORATE
032 003
3: 10%
-> FXBSend2
Preset Edit Menu
FXB Parameters
DELAY
200ms
1:100%
4: 0%
#01
+100
XK-6 Owners Manual 165