Installing The Chassis Intrusion Switch - Dell PowerEdge T310 Hardware Owner's Manual

Figure 3-26. Removing and Installing the Chassis Intrusion Switch
1
3

Installing the Chassis Intrusion Switch

1 Align the chassis intrusion switch with the securing bracket notch.
2 Slide the switch into the securing bracket notch. See Figure 3-26.
3 Connect the chassis intrusion switch cable to the connector on
4 Close the system. See "Closing the System" on page 86.
5 Place the system upright on a flat surface.
6 Reattach any peripherals and connect the system to an electrical outlet.
7 Turn on the system and attached peripherals.
Downloaded from www.Manualslib.com
1
chassis intrusion switch
intrusion connector on the
system board
See Figure 3-26.
the system board.
manuals search engine
2
3
2 chassis intrusion switch cable
Installing System Components
135