Dell PowerEdge T310 Hardware Owner's Manual page 28

Table 1-2. LCD Status Messages (continued)
Code
E122A CPU # VTT
E122C CPU Power
E122D Memory
E122E On-board
E1310 Fan ## RPM
E1410 System Fatal
28
Downloaded from www.Manualslib.com
Text Causes
Specified processor VTT
voltage regulator has failed.
Regulator
failure.
Reseat CPU.
A power fault was
detected when powering
Fault. Power
up the processor.
cycle AC.
One of the memory
regulators has failed.
Regulator #
Failed.
Reseat DIMMs.
One of the on-board
voltage regulators failed.
regulator
failed. Call
support.
RPM of fan is outside of
the intended operating
exceeding
range.
range.
Check fan.
A fatal system error has
been detected.
Error
detected.
About Your System
manuals search engine
Corrective Actions
Reseat the processor.
See "Troubleshooting the
Processor" on page 163.
If the problem persists,
see "Getting Help" on
page 177.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 177.
Reseat the memory
modules. See
"Troubleshooting System
Memory" on page 155.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 177.
See "Troubleshooting
System Cooling Problems"
on page 154.
Check LCD for additional
scrolling messages. Remove
AC power to the system for
10 seconds and restart the
system.
If the problem persists,
see "Getting Help" on
page 177.