Dell PowerEdge T310 Hardware Owner's Manual page 145

5 Slide the system board toward the back of the system, inserting the
6 Using a Phillips screwdriver, tighten the screws.
7 If applicable, replace the SAS backplane. See "Installing the SAS
8 Replace the heat sink and processor. See "Installing a Processor" on
9 Replace the system fan. See "Installing the System Fan" on page 107.
10 Replace all the memory modules and memory blanks. See "Installing
11 If applicable, replace the iDRAC6 Express card. See "Installing an iDRAC6
12 If applicable, replace the iDRAC6 Enterprise card. See "Installing an
13 If applicable, replace all the expansion cards. See "Installing an Expansion
14 Connect all the cables to the system board.
15 Replace the cooling shroud. See "Installing the Cooling Shroud" on page 89.
16 Replace the expansion card stabilizer. See "Installing the Expansion Card
17 Close the system. See "Closing the System" on page 86.
18 Place the system upright on a flat surface.
19 Reattach any peripherals and connect the system to an electrical outlet.
20 Turn on the system and attached peripherals.
Downloaded from www.Manualslib.com
connectors into the cutouts in the chassis.
Backplane" on page 140.
page 129.
Memory Modules" on page 111.
Express Card" on page 119.
iDRAC6 Enterprise Card" on page 121.
Card" on page 115.
Stabilizer" on page 87.
NOTE:
See "Running the System Diagnostics" on page 165 to verify that the new
processor operates correctly. See "Running the Embedded System Diagnostics" on
page 166 for information about running the diagnostics.
manuals search engine
Installing System Components
145