Installing The Intrusion Switch - Dell OptiPlex Small Form Factor 7010 Owner's Manual
Hide thumbs
Also See for OptiPlex Small Form Factor 7010:
- Owner's manual (119 pages) ,
- Owner's manual (119 pages) ,
- Owner's manual (119 pages)
Table of Contents
Advertisement
Available languages
Available languages
Steps
1. Remove the intrusion-switch cable from the routing guides on the chassis.
2. Disconnect the intrusion-switch cable from the connector on the system board.
3. Slide and lift the Intrusion switch away from the computer.
Installing the Intrusion switch
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the Intrusion switch and provides a visual representation of the installation
procedure.
72
Retrait et installation des unités remplaçables sur site (FRU)
Advertisement
Table of Contents
