Ram Disk; Setting The Ram Disk Size; Ram Disk Operations - Kyocera FS 3750 User Manual

2.5. RAM DISK

2.5. RAM DISK
A RAM DISK can be set up as a virtual media device by setting a given amount of the total printer memory
as the RAM DISK. (This is only available for the FS-1750 when the printer's memory has been expanded to
12 MB or more.) By setting up a RAM DISK electronic sorting can be done. (This cuts down the total time of
printing.) Note however that data written to the RAM DISK is lost if the power to the printer is turned off
or the printer is reset. RAM DISK settings can be made from the printer's control panel.
The RAM DISK is set from the printer's user memory. The printer's printing speed may therefore drop
or insufficient memory errors result depending on the value of the RAM DISK setting.

Setting the RAM DISK Size

1.
Press the MODE key.
2.
Press the + or – key and selectý5$0ý',6.ýPRGHý!.
3.
The default setting isý2II. Pressing the ENTER key will cause aý" to flash. Press the + or – keys to dis-
playý2Q and then press the ENTER key.
4.
Press the key to displayý!5$0ý',6.ýVL]H.
5.
Press the ENTER key again, and change the RAM DISK size using the + or –key. It is not possible to make
a setting that exceeds total printer memory. The default value for the RAM DISK is the total printer
memory minus 9 MB. This parameter may be set anywhere fromýíì toýçê depending on the available
printer memory. Press the EXIT key if you want to cancel the setting.
6.
Once the desired RAM DISK size is displayed, press the ENTER key.
7.
Press the EXIT key. Then turn the printer's power off and on again. The setting will be activated after
restart.

RAM DISK Operations

The following operations are available with the RAM DISK.
Read Data
Write Data
Delete Data
Print a List of Data Names
Procedures for all operations are the same as for a memory card. Please see the memory card item for the
given procedure.
2-14