2.4.
Configuring Interfaces
The printer is equipped with both a parallel and serial interface. Independent settings can be made for each
interface. Optional interface can also be installed.
To configure each interface, press the MODE key and use the + or – key to select the interface you wish to make
settings for.
This interface selection does not select which interface data will be received from. The printer auto-
matically selects that interface.
Parallel Interface
The parallel interface mode of this printer supports a bi-directional/high-speed mode. Normally, this inter-
face is used under the default settingý $XWR, see Appendix C. After setting the interface, be sure to reset the
printer or turn the power off at least once. The new setting will be enabled thereafter.
2.4. Configuring Interfaces
2-13