Testing The Expansion Memory - Kyocera FS 3750 User Manual
Kyocera laser printer user's manual fs-1750, fs-3750
Hide thumbs
Also See for FS 3750:
- Specifications (2 pages) ,
- Command reference manual (410 pages) ,
- Technical reference manual (260 pages)
Table of Contents
Advertisement
1.7. Memory Expansion Installation
Removing SIMMs
To remove a SIMM, carefully pull the end catches
slightly outwards and tilt the SIMM as shown, then pull
the SIMM out of the socket.
Reverse the procedure under Withdrawing the Main
Circuit Board from the Printer to put the main circuit
board back into the printer.
Testing the Expansion Memory
After you have finished installing SIMMs in the printer, test the printer to see if the installation has been
successful.
To test the expansion memory, proceed as follows:
1.
Make sure the power switch is off. Plug the power cord into the printer and turn power on.
2.
When the printer is on-line, press the STATUS key.
3.
If the installation has been successful, the amount of memory shown on the status page will correspond
with the amount of expanded memory. (The factory installed memory size is 8 MB for the FS-1750 and
16 MB for the FS-3750.)
1-26
Advertisement
Table of Contents
