Installing The Printer; Positioning The Printer; Clearance; Places To Avoid - Kyocera FS 3750 User Manual

Chapter 1

Installing the Printer

This chapter explains how to unpack and install the printer. The topics covered are:

Positioning the printer

Unpacking and inspection
Names of parts
Setting up and interfacing
1.1. Positioning the Printer

Clearance

Allow at least the necessary minimum clearance around the printer (see below). A total space of 92 cm by
61 cm by 138 cm (36 by 24 by 54 inches) is needed.
30 cm (12 inches)
60 cm (24 inches)

Places to Avoid

Avoid installing the printer in locations subject to:
Direct drafts of hot or cold air
Direct drafts from outside (Avoid locations near doors leading outside.)
Sudden temperature or humidity changes
Sources of high temperature, for example, near stoves or radiators
Excessive dust
Vibration
Ammonia or other harmful fumes. (If you are planning to fumigate the room, or make liberal use of insec-
ticide, remove the printer first!)
Excessive sunlight or humidity
Lack of ventilation
Low air pressure, e.g., located more than 2000 meters (6500 feet) above sea level
30 cm (12 inches)
25 cm (10 inches)
1.1. Positioning the Printer
40 cm (16 inches)
[20 cm (8 inches) when the
face-up output tray* is not
installed.]
* Optional with the FS-1750
1-1