Printer Settings; Parallel Setting - Kyocera FS-1118MFP Advanced Operation Manual

Parallel Setting

System Menu/
Counter
or
System Setting
Enter
or
Parallel Setting
Enter
ADVANCED OPERATION GUIDE

3 Printer Settings

This chapter explains the procedures required to use the printer functions of the
machine.
The settings needed to use the machine as a network printer can be made from the
operation panel or using COMMAND CENTER. The procedures in this chapter only
explain how to make the settings from the operation panel. To make settings using
COMMAND CENTER, refer to Using COMMAND CENTER on page 8-1.
The parallel interface supports a bi-directional/high-speed mode according to IEEE
standards. Use a parallel printer cable that complies with the IEEE1284 standard.
Four modes are available.
Item
Auto (default)
Normal
High speed
Nibble(high)
1
Access Parallel Setting.
If you are unsure how to use this route map refer to Accessing Menu Items on
page vii.
2
Press or to select the parallel interface mode setting and press Enter.
The display shows Completed and returns to the System Setting screen.
Description
The machine automatically changes its communication
mode to that of the host computer. Ordinarily, you should
leave this setting unchanged.
The machine uses the standard communication method
prescribed for Centronics interfaces.
This mode enables faster data transmission between the
machine and the host computer. (Select this mode if
printing problems occur when the machine is connected
to a workstation.)
High speed data communication is used in compliance
with the IEEE 1284 standard.
3-1