Pppoe Ia Vlan Configuration - ZyXEL Communications VES1724-56 User Manual

32.5 PPPoE IA VLAN Configuration

Click Advanced Application > PPPoE IA Configuration in the navigation panel, and then click
the VLAN link to display the screen as shown. Use this screen to have the Switch add extra
information to PPPoE discovery packets from PPPoE clients on a per-VLAN basis.
Note: This screen is not available if you have enabled PPPoE IA globally in the Advanced
Application > PPPoE IA Configuration screen.
You can additionally configure whether to add/replace PPPoE IA option 82 tags on a per-port basis
in the Basic Setting > Port Setup screen (see
Figure 180 Advanced Application > PPPoE IA Configuration > VLAN
The following table describes the labels in this screen.
Table 136 Advanced Application > PPPoE IA Configuration > VLAN
LABEL
VID
Append Circuit
ID
Circuit ID
Information
VES1724-56 User's Guide
DESCRIPTION
Enter the ID number of the VLAN to which PPPoE IA settings you configure here apply.
Select this option to have the Switch add the user-defined identifier string (specified in the
Circuit ID Information field) to PADI or PADR packets from PPPoE clients.
If you leave this option unselected and do not configure any Circuit ID string (using CLI
commands) on the Switch, the Switch will use its host name.
Enter a string of up to 63 ASCII characters that the Switch adds into the Agent Circuit ID
sub-option for PPPoE discovery packets with the specified VLAN tag. Spaces are allowed.
Otherwise, select the second option to have the Switch use its host name.
Section 8.9 on page 82).
Chapter 32 PPPoE IA
293