ZyXEL Communications VES1724-56 User Manual page 296

Chapter 32 PPPoE IA
Table 137 Advanced Application > ADSL Fallback > PVC (continued)
LABEL
PVID
Encapsulation
Priority
FCS
MVLAN
Add
Cancel
Index
Active
Port
VPI
VCI
PVID
Encap.
Priority
FCS
MVLAN
Delete
Cancel
Paging
296
DESCRIPTION
Enter the PVID (Port VLAN ID) that the Switch assigns to untagged frames received on this
channel.
This must be the VLAN ID of a VLAN that is already configured. The port that you are
configuring and the uplink port must also be set to the fixed status in the VLAN.
You should also select Tx Tagging for the VLAN to have the Switch tag all the outgoing
frames on the DSL port with this VLAN ID.
Specify the encapsulation type (llc or vc) for this channel.
Assign a default IEEE 802.1p default priority (0 to 7). This is the priority value to add to
incoming frames without a (IEEE 802.1p) priority tag.
Select fcs to have the Switch include the original FCS (Frame Check Sequence) in the
bridged frames. Otherwise, select no fcs.
Select this option to turn on multicast VLAN for this channel.
Multicast VLAN allows one single multicast VLAN to be shared among different subscriber
VLANs on the network. This improves bandwidth utilization by reducing multicast traffic in
the subscriber VLANs and simplifies multicast group management.
Click Add to insert a new PVC entry to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the above fields to your previous configuration.
This is the index number of the channel on this port. Click a number to edit that channel.
This field displays whether the channel is enabled (Yes) or not (No).
This field displays the DSL port for which this channel is configured.
This field displays the Virtual Path Identifier (VPI) for this channel.
This field displays the Virtual Circuit Identifier (VCI) for this channel.
This field displays the PVID (Port VLAN ID) to assign to untagged frames received on this
channel.
This field displays the encapsulation type (llc or vc) for this channel.
This field displays the priority value (0 to 7) that the Switch adds to frames that come in on
this channel without a (IEEE 802.1p) priority tag.
This field displays whether the original FCS is included in the frames.
This field displays whether the multicast VLAN is active for this channel.
Select the entries you want to remove and click Delete to remove them.
Click Cancel to clear the Delete check boxes.
Select Prev or Next to show the previous/next screen or select a page number from the
drop-down list box to display a specific page if all entries cannot be seen in one screen.
VES1724-56 User's Guide