ZyXEL Communications VES1724-56 User Manual page 241

Table 103 Advanced Application > Auth and Acct > TACACS+ Server Setup (continued)
LABEL
Shared Secret
Delete
Apply
Cancel
Accounting
Server
Timeout
Index
IP Address
TCP Port
Shared Secret
Delete
Apply
Cancel
VES1724-56 User's Guide
DESCRIPTION
Specify a password (up to 32 alphanumeric characters) as the key to be shared between
the external TACACS+ server and the Switch. This key is not sent over the network. This
key must be the same on the external TACACS+ server and the Switch.
Check this box if you want to remove an existing TACACS+ server entry from the Switch.
This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Use this section to configure your TACACS+ accounting settings.
Specify the amount of time in seconds that the Switch waits for an accounting request
response from the TACACS+ server.
This is a read-only number representing a TACACS+ accounting server entry.
Enter the IPv4 or IPv6 address of an external TACACS+ accounting server in dotted
decimal notation.
The default port of a TACACS+ server for accounting is 49. You need not change this value
unless your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared between
the external TACACS+ accounting server and the Switch. This key is not sent over the
network. This key must be the same on the external TACACS+ accounting server and the
Switch.
Check this box if you want to remove an existing TACACS+ accounting server entry from
the Switch. This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 25 Authentication and Accounting
241