ZyXEL Communications VES1724-56 User Manual page 169

The following table describes the labels in this screen.
Table 66 Advanced Application > Spanning Tree Protocol > MRSTP
LABEL
Status
Tree
Active
Bridge Priority
Hello Time
Max Age
Forwarding Delay
Port
*
Active
Priority
Path Cost
Tree
VES1724-56 User's Guide
DESCRIPTION
Click Status to display the MRSTP Status screen (see
This is a read only index number of the STP trees.
Select this check box to activate an STP tree. Clear this checkbox to disable an STP tree.
Note: You must also activate Multiple Rapid Spanning Tree in the Advanced Application
> Spanning Tree Protocol > Configuration screen to enable MRSTP on the Switch.
Bridge priority is used in determining the root switch, root port and designated port. The
switch with the highest priority (lowest numeric value) becomes the STP root switch. If all
switches have the same priority, the switch with the lowest MAC address will then become
the root switch. Select a value from the drop-down list box.
The lower the numeric value you assign, the higher the priority for this bridge.
Bridge Priority determines the root bridge, which in turn determines Hello Time, Max Age
and Forwarding Delay.
This is the time interval in seconds between BPDU (Bridge Protocol Data Units)
configuration message generations by the root switch. The allowed range is 1 to 10
seconds.
This is the maximum time (in seconds) the Switch can wait without receiving a BPDU
before attempting to reconfigure. All Switch ports (except for designated ports) should
receive BPDUs at regular intervals. Any port that ages out STP information (provided in the
last BPDU) becomes the designated port for the attached LAN. If it is a root port, a new
root port is selected from among the Switch ports attached to the network. The allowed
range is 6 to 40 seconds.
This is the maximum time (in seconds) the Switch will wait before changing states. This
delay is required because every switch must receive information about topology changes
before it starts to forward frames. In addition, each port needs time to listen for conflicting
information that would make it return to a blocking state; otherwise, temporary data loops
might result. The allowed range is 4 to 30 seconds.
As a general rule:
Note: 2 * (Forward Delay - 1) >= Max Age >= 2 * (Hello Time + 1)
This field displays the port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to activate STP on this port.
Configure the priority for each port here.
Priority decides which port should be disabled when more than one port forms a loop in a
switch. Ports with a higher priority numeric value are disabled first. The allowed range is
between 0 and 255 and the default value is 128.
Path cost is the cost of transmitting a frame on to a LAN through that port. It is
recommended to assign this value according to the speed of the bridge. The slower the
media, the higher the cost-see
Select which STP tree configuration this port should participate in.
Chapter 14 Spanning Tree Protocol
Figure 100 on page
Table 61 on page 160 for more information.
167).
169