Table of Contents
Advertisement
2.COPY FUNCTIONS
Selecting the drawer or the bypass tray to copy
The equipment has two paper sources, the drawer and the bypass tray. You usually use the drawer to make copies, but
you may sometimes want to load different paper from that loaded in the drawer. Some paper sizes and types require you
to use the bypass tray.
P.29 "Acceptable media types"
When you use overhead transparencies, remove them one by one every time they are ejected. If you leave them lying
one on top of one another, they could be curled and not be good for projection.
If the paper source runs out of paper, the error message appears on the LCD screen and copying stops. Load paper, so
that the equipment automatically resumes copying.
Selecting the paper source automatically
When you load paper on the bypass tray, the paper source automatically changes from the drawer to the bypass tray. The
LCD screen automatically changes so that you can easily set the paper size and type for the bypass tray.
Press the , , , or
1
The LCD screen below illustrates "NONSIZE" is selected.
BYPASS
COM10
CANCEL
Press the [SETTING/OK] button.
2
3
Press the , , , or
The LCD screen below illustrates "PLAIN" is selected.
BYPASS PAPER TYPE
PLAIN
THICK2
TRANSPARENCY
4
Press the [SETTING/OK] button to exit from the menu.
You are ready to use the selected paper size and type.
After copying, remove the paper from the bypass tray, so that the paper source automatically changes back to the drawer.
Selecting the paper source manually
Follow the steps below to select the paper source manually and make copies.
1
Place the original.
Load paper in the paper source that you want to use.
2
P.31 "Loading paper in the drawer"
P.33 "Loading paper on the bypass tray"
P.35 "Loading an envelope on the bypass tray"
button to select the size of paper you loaded on the bypass tray.
NONSIZE
4
4
button to select the type of paper you loaded on the bypass tray.
THICK1
1
ENVELOPE
2
2 COPY FUNCTIONS
Basic Copy Procedure
55
Advertisement
Table of Contents
