Environmental Conditions; Temperature/Humidity; Vibration & Shock - Epson StylusPRO 7000 Service Manual

EPSON Stylus Pro 7000

1.1.8 Environmental Conditions

TEMPERATURE/HUMIDITY

See the following table.
Table 1-11. Environmental Conditions
Condition Temperature
10~35°C
Operating
(50~95°F)
-20~40°C
Storage
(-4~104°F)
-20~60°C
Transportation
(-4~140°F)
Notes:
1) When storing the printer, make sure the printheads are in the home (capped)
position. If necessary switch power on, wait for the printheads to move to the
home position, and then switch power off.
2) Before transporting the printer, remove the ink cartridges and turn the ink
valves screws to the closed position. Also make sure the printheads are in the
home, capped, position. After transporting the printer, install new ink
cartridges.
3) If the temperature drops below -15°C (5°F), the ink in the cartridges and
printheads freezes. The ink thaws completely after three hours at 25°C (77°F).
90
80
70
60
50
Humidity (%)
40
30
20
10
Figure 1-2. Print Temperature and Humidity
Product Description
Humidity Notes
• Less than a month at
20~80%
40°C (104°F)
• Less than 120 hours at
20~85%
60°C (140°F)
• With no freezing
5-85%
10 20 27 30 35 40
Temperature (°C)
VIBRATION & SHOCK
See the following table.
Table 1-12. Vibration and Shock
Vibration
Condition
Resistance
0.15G
Operating
10~55Hz
0.5G
Storage
10~55Hz
Notes:
* Make sure the printhead is capped during transportation and storage. To cap
the printhead, turn the power on (with ink cartridges installed) and turn the
power off when the printheads are capped.
* To thaw frozen ink in the printer or cartridge, leave the printer out at a
temperature of 25°C (77°F) for approximately three hours.
Features
Revision A
Shock
Notes
Resistance
1G
maximum 1ms
X/Y/Z directions
2G
maximum 2ms
20