Sony SRW-5800 Operation Manual page 155

Item number Item
616 VITC POSITION-1
select (PAL)
617 VITC POSITION-2
select (PAL)
618 LTC OUTPUT
PHASE select
619 EXT LTC MODE
620 SUPERIMPOSED
CHARACTER
622 CHARACTER H-
POSITION
623 CHARACTER V-
POSITION
Setting Function
9,322 line When 25PsF/50i mode is selected on the VTR, this setting
specifies the lines in which the VITC signal is inserted.
It can be inserted in any lines from 9,322 to 22,335.
[19,332 line]
22,335 line
Note
Items 616 and 617 allow VITC to be inserted in two lines.
9,322 line When 25PsF/50i mode is selected on the VTR, this setting
specifies the lines in which the VITC signal is inserted.
It can be inserted in any lines from 9,322 to 22,335.
[21,334 line]
22,335 line
Note
Items 616 and 617 allow VITC to be inserted in two lines.
input Selects the LTC output phase.
auto input: Same phase as input video.
[output]
auto: When editing, same phase as input video; otherwise
output: Same phase as output video.
direct Selects the recording mode when the internal time code
[regene] generator is set to regenerate the input from the TIME
CODE IN connector (menu item 607 is set to "ext-LTC", and
menu item 606 is set to "regene").
direct: Records the time code input from the TIME CODE
regene: Regenerates the time code input from the TIME
[off]
Specifies whether or not to superimpose time data and
on operating status information on the signal output from the
MONITOR connector of SD SDI OUT, the SD OUT
COMPOSITE connector and MONITOR connector of HD
SDI OUTPUT.
off: No information is superimposed.
on: Information is superimposed.
0 Sets the horizontal position of text information
superimposed on the signal output from the MONITOR
connector of SD SDI OUT, the SD OUT COMPOSITE
[8]
connector and MONITOR connector of HD SDI OUTPUT. A
setting of 0 displays the information at the left edge of the
15
screen, and the position moves to the right as the setting is
increased. There are 16 possible settings, from 0 to 15.
0 Sets the vertical position of text information superimposed
on the signal output from the MONITOR connector of SD
SDI OUT, the SD OUT COMPOSITE connector and
[22]
MONITOR connector of HD SDI OUTPUT. A setting of 0
displays the information at the bottom of the screen, and
23
the position moves up as the setting is increased. There are
24 possible settings, from 0 to 23.
Note
If two-line display is selected in item 626, sometimes the
second line will disappear in the middle of the screen.
(playback, recording, etc.), same phase as output
video.
IN connector unaltered on the tape.
CODE IN connector with the internal time code
generator.
155
Menu List