Sony SRW-5800 Operation Manual page 148

Item number Item
303 POSTROLL TIME
304 VAR SPEED RANGE
FOR
SYNCHRONIZATION
305 EDIT FIELD select
306 SYNCHRONIZE
148
Menu List
Setting Function
0 sec This sets the tape running time after passing the OUT point
(postroll time) in automatic editing.
The range is from 0 to 30 seconds, in steps of 1 second.
[5 sec]
30 sec
[narrow]
Specifies the variable tape speed range when the variable
wide speed playback is executed by a remote control unit
connected to the REMOTE 1-IN(9P) connector.
narrow: –0.5 to +1 times normal tape speed (HDCAM-SR),
wide: –1 to +2 times normal tape speed (HDCAM-SR), –
Notes
• When this item is set to "narrow", variable speed
• When an editing control unit such as BVE-9100 is
[1F]
Selects the start timing for editing when performing tape
2F editing.
1F/2F 1F: Start editing from field 1 and end on field 2.
2F: Start editing from field 2 and end on field 1.
1F/2F: Following received timing commands.
Note
When the system frequency of this unit is PsF mode, the
unit always operates with the 1F setting.
[accurate]
When this unit is used as a controller for editing control of
rough another VTR connected through a 9-pin remote cable, this
off selects whether or not to carry out phase synchronization
of the two VTRs, and also the editing accuracy when
carrying out synchronization.
accurate: Editing is carried out with an accuracy of ±0
rough: Editing is carried out with an accuracy of ±1 frame.
off: Synchronization is not carried out.
–1 to +2 times normal tape speed (HDCAM), or –1 to
+3 times normal tape speed (Digital Betacam).
1.15 to +2.45 times normal tape speed (HDCAM), or –
1.15 to +3.45 times normal tape speed (Digital
Betacam).
playback is possible within the range of speed specified
for the respective formats.
connected for DT editing, select "wide".
frames.