4.8
Sending a fax using an additional line ([Select Line])
4.8
Sending a fax using an additional line ([Select Line])
Using an additional line
When two lines are operating, you can select a line for sending a fax.
Faxes are usually transmitted using an idle line. Lines can be used to transmit faxes according to usages 's
situation.
Tips
-
When registering destinations with an address book, you can configure the lines used to transmit faxes
in addition to registering fax numbers.
-
This function cannot be used together with the following functions.
–
Polling TX, Polling TX (Bulletin Board).
Operations required to use this function (for administrators)
Configure a specific function for additional line. If you configure a function that differs from the one assigned
to the first line, you can use the two lines differently.
For details on how to configure the settings, refer to page 11-31.
Tips
-
You cannot specify a line if [Multi Line Usage Settings] is set to [RX Only].
d-Color MF552/452/362/282/222
Line 2
4
4-15