Installing The Door - Lopi Spirit Bay B-Vent Owner's Manual

F
INALIZING THE
4 Install the door (see the illustration below).
Place the door face
a
down on a
non-scratching
surface.
Door Latch Plate
g
Swing the door to the left,
lifting slightly on the door
handle. The door latch
plate on the heater inserts
into the slot on the
mounting angle. If the
door does not secure to
the heater, adjust the door
latch plate up or down to
ensure proper latching.
f
Attach the handle to the
door using the T-nut.
When tight, the handle
should be pointing down.
I
NSTALLATION
Remove the hinge plate (and hinge pins) from
the heater. Attach the hinge plate to the door
frame with the two remaining screws. Make
sure the plate butts up against the outside edge
of the door frame.
(C .) -
ONT
For qualified installers only!
Remove the four screws in the door
b
frame with a 5/16Ó socket wrench.
Attach the mounting angle to the door
with two of the screws. Make sure the
angle butts up against the outside edge
of the door frame.
c
d
5/16Ó Socket
Wrench
Insert the hinge pins
into hinge plate.
e
Insert the
hinge pins
into the
hinges on
the heater.
P 11
AGE